The Zoom OMAP-L138 eXperimenter Kit is a low-cost application development kit for evaluating the functionality of Texas Instruments' highly integrated and energy-efficient OMAP-L138 applications processor.
Panel | ||||||||||
---|---|---|---|---|---|---|---|---|---|---|
| ||||||||||
Unterlagen zum eXperimenters Board
Panel | ||||||||||
---|---|---|---|---|---|---|---|---|---|---|
|
Das Schema des eXperimenters Board ist auf derLogic PD Seite oder lokal erhältlich. Auf der Grundplatte ist das SOM-Modul aufgesteckt (System-On-Module) Auch dieses Schema ist lokal abgelegt.
Der Codec im Audiopfad ist ein TLV320AIC3106, siehe Codecs.
Code Composer Studio und C6000 Compiler
siehe Code Composer Studio
DSP direkt aus Matlab/Simulink programmieren
siehe Code Composer Studio
Linux auf dem eXperimenter Kit mit Emdebian
siehe Buildroot auf dem ZOOM-Board
Zusatzboard GPIO
Da die beiden LED sowie Taster auf dem Zoom Board nicht über normale GPIO benützt werden können, sondern via I²C-Expander Bus angeschlossen sind, wurde für den Stecker J30 ein Zusatzboard hergestellt.
Dabei ist zu beachten, dass die Pins des OMAP-Prozessors gemultiplext sind, das heisst zum Beispiel, der auf dem Zusatzboard verwendete GP0[2] ist auch noch ein Pin der McBSP usw. Falls also die McBSP ebenfalls verwendet werden möchte, darf unter Umständen dieser Pin nicht als GPIO konfiguriert werden.
Panel | ||||||||||
---|---|---|---|---|---|---|---|---|---|---|
| ||||||||||
GPIO Extension
As the two LEDs and buttons on the Zoom board cannot be used via normal GPIO, but are connected via the I²C expander bus, an additional board was produced for the J30 connector.
It should be noted that the pins of the OMAP processor are multiplexed, i.e. the GP0[2] used on the additional board is also a pin of the McBSP etc. If the McBSP is also to be used, this pin may not be configured as a GPIO.
I/0 | pin | alternative function |
---|
GP0[0] | 92 | AXR8 / CLKS1 / ECAP1_APWM1 |
GP0[1] | 81 | AXR9 / DX1 |
GP0[2] | 23 | AXR10 / DR1 |
GP0[6] | 17 | AXR14 / CLKR1 |
GP0[13] | 73 | AFSR |
GP0[15] | 77 | ACLKR |
Steckverbinder
Das Zusatzboard ist über einen Stecker mit 100 Pins angeschlossen. Auf dem Board sind noch vier weitere Stecker gleichen Typs vorhanden. Diese haben folgende Bezeichnung:
Beschreibung | Bezeichnung | Lieferant | Bestellnummer |
---|---|---|---|
Stecker | DF40C-100DS-0.4V(51) | Mouser | 798-DF40C100DS0.4V51 |
Buchse | DF40C-100DP-0.4V(51) | Mouser | 798-DF40C100DP0.4V51 |
borderColor | #FFFFFF |
---|---|
bgColor | #B4E380 |
titleColor | black |
titleBGColor | #88D66C |
title | Datasheet of the processor |